Quick Link
Quick Contact
Address
No.89,Pingliang Avenue, Nanjing, China
Tel
+86-178-9884-8998
E-mail:
myuav@myuav.com.cnOur Newsletter
Subscribe to our newsletter for discounts and more.
In counter-UAV detection scenarios, ground-based radar often suffers from reduced effective detection range against "low, slow, and small" (LSS) targets due to obstruction by terrain or structures and interference from ground clutter. Meanwhile, airborne platforms—such as drones—face a trilemma: limited endurance, power supply challenges, and constraints on payload capacity. The MYUAV DJI FC200 tethered drone system, equipped with a four-panel phased-array radar, offers a pragmatic solution. By using a tether to elevate the radar to a height of 120 meters, the system can operate continuously for hours, significantly extending the line-of-sight range and ensuring that every watt of transmitted power is more effectively utilized to "see" the intended targets.

Why FC200?
The FC200 is an octocopter (four-arm, eight-rotor configuration) with an IP55 ingress protection rating, capable of withstanding Level 6 winds. Its voltage architecture has been stepped up from the 60V standard found in consumer-grade drones to 120V; combined with flat-wire motors and 68-inch carbon-fiber propellers, it achieves a maximum payload capacity of 200kg—providing sufficient margin to carry a substantial four-sided phased-array radar system.
In its standard configuration, the drone can hover for only 4 minutes when fully loaded and powered by its onboard batteries. A tethered power system resolves this limitation: a 120-meter cable provides continuous power from the ground, enabling the drone to remain airborne for over 6 hours. An altitude of 120 meters is sufficient to clear ground clutter and low-level obstructions, ensuring an unobstructed view of the surrounding airspace.

Power Supply Chain: From 1500V to Clean Voltage
Ground-based unit: 80kW tethered power station, with an output of 1450–1500V DC and a voltage fluctuation within ±1%.
Airborne unit: Two "bionic" power modules, each with a rated capacity of 33 kW (66 kW total). These utilize an original-equipment-style plug-in battery design, ensuring the FC200’s existing structure remains intact and its warranty stays valid. The system accepts a 1500V input and provides power to the 120V propulsion platform and radar systems, with a conversion efficiency of ≥96% and a voltage stability of ±1%.

Radar Power Supply: The T/R modules of a four-faced phased-array radar are highly sensitive to voltage ripple. Excessive ripple can distort the transmitted linear frequency-modulated (LFM) signals and couple into the receiver front-end, degrading the noise figure—ultimately compromising both ranging accuracy and detection range. By converting the 120V supply into the specific operating voltages required by the radar while maintaining stringent ripple specifications, the system ensures that the radar’s transmission spectrum and receiver noise floor remain unaffected by power quality issues, thereby preserving the radar's detection sensitivity.